Ocean-optics USB Programmer Manuel d'utilisateur télécharger pdf (Page 5)

USB Programmer Installation and Operation Instructions

000-20000-080-01-201009 5

Note

Do not interrupt the programming process for any reason! If the programming

process is interrupted, permanent corruption can occur in the EEPROM on the

USB device. Consult the Recovering a Corrupted EEPROM section of this

document for a procedure that may rectify this condition.

10. Disconnect the USB device from the PC once programming is complete.

11. Reattach the USB device to the PC to activate the new program.

12. Wait 10 seconds and click the

Refresh Tree button.

The device should appear in the appropriate category.

1 2 3 4 5 6

Pas de commentaire

Ocean-optics USB Programmer Manuel d'utilisateur Page 5